In multi-user (MU) downlink beamforming, a high spectral efficiency along with a low transmit power is achieved by separating multiple users in space rather than in time or frequency using spatially selective transmit beams. For streaming media applications, multi-group multicast (MGM) downlink beamforming is a promising approach to exploit the broadcasting property of the wireless medium to transmit the same information to a group of users. To limit inter-group interference, the individual streams intended for different multicast groups are spatially separated using MGM downlink beamforming. Spatially selective downlink beamforming requires the employment of an array of multiple antennas at the base station (BS). The hardware costs associated with the use of multiple antennas may be prohibitive in practice. A way to avoid the expensive employment of multiple antennas at the BS is to exploit user cooperation in wireless networks where ...

The major contribution of this thesis is on the problem of transmit beamforming to multiple cochannel multicast groups. Two viewpoints are considered: i) minimizing total transmission power while guaranteeing a prescribed minimum signal-to-interference-plus-noise ratio (SINR) at each receiver; and ii) a "fair" approach maximizing the overall minimum SINR under a total power budget. The core problem is a multicast generalization of the multiuser downlink beamforming problem; the difference is that each transmitted stream is directed to multiple receivers, each with its own channel. Such generalization is relevant and timely, e.g., in the context of the emerging WiMAX and UMTS-LTE wireless networks. The joint multicast beamforming problem is in general NP-hard, motivating the pursuit of computationally efficient quasi-optimal solutions. In chapter 1, it is shown that semidefinite relaxation coupled with suitable randomization / cochannel multicast power control yield computationally efficient high-quality ...

In this thesis, the problem of resource allocation is investigated in multiuser, multi-antenna downlink wireless systems in which spatial multiplexing is employed in the physical layer. The thesis consists of two main parts; in the first, the interest is focused on optimizing system’s performance in terms of users’ transmission rate. Under this context, a low complexity but highly performing user selection algorithm is presented for the flat-fading channel, when zero-forcing beamforming is employed at the BS and the aim is to maximize system’s throughput. For the more interesting case where the transmission is performed simultaneously over a number of parallel subchannels, two fairness-aware resource allocation problems are investigated in the sense that certain QoS constraints are considered. Typically, this kind of problems fall within the NP class because of the integer nature of the involved user selection procedure. Hence, several ...

This work considers a Broadcast Channel (BC) system, where the transmitter is equipped with multiple antennas and each user at the receiver side could have one or more antennas. Depending on the number of antennas at the receiver side, such a system is known as Multiple-User Multiple-Input Single-Output (MU-MISO), for single antenna users, or Multiple-UserMultiple-InputMultiple-Output (MU-MIMO), for several antenna users. This model is suitable for current wireless communication systems. Regarding the direction of the data flow, we differentiate between downlink channel or BC, and uplink channel or Multiple Access Channel (MAC). In the BC the signals are sent from the Base Station (BS) to the users, whereas the information from the users is sent to the BS in the MAC. In this work we focus on the BC where the BS applies linear precoding taking advantage of multiple antennas. The ...

With the rapidly growing of the customers’ data traffic demand, improving the system capacity and increasing the user throughput have become essential concerns for the future fifth-generation (5G) wireless communication network. In this context, device-to-device (D2D) communication and in-band full-duplex (FD) are proposed as potential solutions to increase the spatial spectrum utilization and the user rate in a cellular network. D2D allows two nearby devices to communicate without base station (BS) participation or with limited participation. On the other hand, FD communication enables simultaneous transmission and reception in the same frequency band. Due to the short distance property of D2D links, exploiting the FD technology in D2D communication is an excellent choice to further improve the cellular spectrum efficiency and the users’ throughput. However, practical FD transceivers add new challenges for D2D communication. For instance, the existing FD devices cannot ...

Multi-user multi-antenna wireless communication systems have become essential due to the widespread of smart applications and the use of the Internet. Ultra-dense deployment of small cell networks has been recognized as an effective way to meet the exponentially growing mobile data traffic and to accommodate increasingly diversified mobile applications for beyond 5G and future wireless networks. Small cells using low power nodes are meant to be deployed in hot spots, where the number of users varies strongly with time and between adjacent cells. As a result, small cells are expected to have burst-like traffic, which makes the static time division duplex (TDD) frame configuration strategy, where a common TDD pattern is selected for the whole network, not able to meet the users' requirements and the traffic fluctuations. Dynamic TDD (DTDD) technology which allows the cells to independently adapt their TDD ...

Abstract Future mobile networks are envisioned to provide wireless access to a massive number of devices. The substantial increase in connectivity comes mainly from machine-type communication (MTC), for which a large number of low-rate transmissions take place. Accommodating access for such a large number of user equipment (UEs) can be inefficient if applied to current network architectures, which are mainly based on orthogonal multiple access (OMA) and scheduling-based transmissions. This is due to the resulting control overhead and increased access delay. The framework of non-orthogonal multiple access (NOMA) has attracted attention recently as a promising solution to tackle these issues. It allows multiple UEs to access the network simultaneously over the same resources, and provides naturally, the support for grant-free access, in which no explicit scheduling of the UEs is required. Motivated by the potential benefits of NOMA in enabling ...

This work is focused on the synthesis of Digital Signal Processing (DSP) circuits usingc specific hardware architectures. Due to its complexity, the design process has been subdivided into separate tasks, thus hindering the global optimization of the resulting systems. The author proposes the study of the combination of two major design tasks, Word-Length Allocation (WLA) and High-Level Synthesis (HLS), aiming at the optimization of DSP implementations using modern Field Programmable Gate Array devices (FPGAs). A multiple word-length approach (MWL) is adopted since it leads to highly optimized implementations. MWL implies the customization of the word-lengths of the signals of an algorithm. This complicates the design, since the number possible assignations between algorithm operations and hardware resources becomes very high. Moreover, this work also considers the use of heterogeneous FPGAs where there are several types of resources: configurable logic-based blocks (LUT-based) ...

The envisioned rapid and exponential increase of wireless data traffic demand in the next years imposes rethinking current wireless cellular networks due to the scarcity of the available spectrum. In this regard, three main drivers are considered to increase the capacity of today's most advanced (4G systems) and future (5G systems and beyond) cellular networks: i) use more bandwidth (more Hz) through spectral aggregation, ii) enhance the spectral efficiency per base station (BS) (more bits/s/Hz/BS) by using multiple antennas at BSs and users (i.e. MIMO systems), and iii) increase the density of BSs (more BSs/km2) through a dense and heterogeneous deployment (known as dense heterogeneous cellular networks). We focus on the last two drivers. First, the use of multi-antenna systems allows exploiting the spatial dimension for several purposes: improving the capacity of a conventional point-to-point wireless link, increasing the number ...

Direct-sequence code-divisionmultiple-access (DS-CDMA) and multiple-input multiple-output (MIMO) wireless networks form the physical layer of the current generation of mobile networks and are anticipated to play a key role in the next generation of mobile networks. The improvements in capacity, data-rates and robustness that these networks provide come at the cost of increasingly complex interference suppression and resource allocation. Consequently, efficient approaches to these tasks are essential if the current rate of progression in mobile technology is to be sustained. In this thesis, linear minimum mean-square error (MMSE) techniques for interference suppression and resource allocation in DS-CDMA and cooperative MIMO networks are considered and a set of novel and efficient algorithms proposed. Firstly, set-membership (SM) reduced-rank techniques for interference suppression in DS-CDMA systems are investigated. The principals of SM filtering are applied to the adaptation of the projection matrix and reduced-rank ...

The use of multiple antennas at base stations and user devices is a key component in the design of cellular communication systems that can meet the capacity demands of tomorrow. The downlink transmission from base stations to users is particularly limiting, both from a theoretical and a practical perspective, since user devices should be simple and power-efficient, and because many applications primarily create downlink traffic (e.g., video streaming). The potential gain of employing multiple antennas for downlink transmission is well recognized: the total data throughput increases linearly with the number of transmit antennas if the spatial dimension is exploited for simultaneous transmission to multiple users. In the design of practical cellular systems, the actual benefit of multiuser multiantenna transmission is limited by a variety of factors, including acquisition and accuracy of channel information, transmit power, channel conditions, cell density, user ...

Multi-input and multi-output (MIMO) radars achieve high resolution of arrival direction by transmitting orthogonal waveforms, performing matched filtering at the receiver end and then jointly processing the measurements of all receive antennas. This dissertation studies the use of compressive sensing (CS) and matrix completion (MC) techniques as means of reducing the amount of data that need to be collected by a MIMO radar system, without sacrificing the system’s good resolution properties. MIMO radars with sparse sensing are useful in networked radar scenarios, in which the joint processing of the measurements is done at a fusion center, which might be connected to the receive antennas via a wireless link. In such scenarios, reduced amount of data translates into bandwidth and power saving in the receiver-fusion center link. First, we consider previously defined CS-based MIMO radar schemes, and propose optimal transmit antenna ...

An important specificity of wireless communication channels are the rapid fluctuations of propagation coefficients. This effect is called fading and is caused by the motion of obstacles, scatterers and reflectors standing along the different paths of electromagnetic wave propagation between the transmitting and the receiving terminal. These changes in the geometry of the wireless channel prompt the attenuation coefficients and the relative phase shifts between the multiple propagation paths to vary. This suggests to model the channel coefficients (the transfer matrix) as random variables. The present thesis studies information rates for reliable transmission of information over fading channels under the realistic assumption that the receiver has only imperfect knowledge of the random fading state. While the over-idealized assumption of perfect channel-state information at the receiver (CSIR) gives rise to many simple expressions and is fairly well understood, the settings with ...

This dissertation details three approaches for direction-of-arrival (DOA) estimation or beamforming in array signal processing from the perspective of sparsity. In the first part of this dissertation, we consider sparse array beamformer design based on the alternating direction method of multipliers (ADMM); in the second part of this dissertation, the problem of joint DOA estimation and distorted sensor detection is investigated; and off-grid DOA estimation is studied in the last part of this dissertation. In the first part of this thesis, we devise a sparse array design algorithm for adaptive beamforming. Our strategy is based on finding a sparse beamformer weight to maximize the output signal-to-interference-plus-noise ratio (SINR). The proposed method utilizes ADMM, and admits closed-form solutions at each ADMM iteration. The algorithm convergence properties are analyzed by showing the monotonicity and boundedness of the augmented Lagrangian function. In addition, ...

Wireless networks and power distribution grids are experiencing increasing demands on their efficiency and reliability. Judicious methods for allocating scarce resources such as power and bandwidth are of paramount importance. As a result, nonlinear optimization and signal processing tools have been incorporated into the design of contemporary networks. This thesis develops schemes for efficient resource allocation (RA) in such dynamic networks, with an emphasis in stochasticity, which is accounted for in the problem formulation as well as in the algorithms and schemes to solve those problems. Stochastic optimization and decomposition techniques are investigated to develop low-complexity algorithms with specific applications in cross-layer design of wireless communications, cognitive radio (CR) networks and smart power distribution systems. The costs and constraints on the availability of network resources, together with diverse quality of service (QoS) requirements, render network design, management, and operation challenging ...