Modern modulation methods as used in 3rd generation mobile communications (UMTS) generate strongly fluctuating transmission signal envelopes with high peak-to-average power ratios. These properties result in significant distortion due to the nonlinear behavior of the radio-frequency power amplifier (RF PA). We propose different nonlinear model structures for such amplifiers, based on memory polynomials and frequency-domain Volterra kernel expansion, where we can reduce the number of free parameters by 80% compared to traditional Volterra series approaches. Because these nonlinear models incorporate memory, we are able to model the nonlinear distortion of RF PAs with sufficient accuracy (e.g., −30 dB relative modeling error ), including the wideband case (bandwidth B = 20 MHz as needed for four-carrier WCDMA). Furthermore, we propose a method to construct RF PA models from frequency-dependent AM/AM and AM/PM conversions. For the compensation of the nonlinearities, we analyze ...

The radio frequency power amplifier (RF-PA) within a digital wireless transmitter is a critical component regarding both the energy consumption and the signal quality. Especially due to today's broadband multicarrier modulation methods that generate signals with high peak-to-average power ratio, it is very hard to construct RF-PAs that achieve good energy efficiency and fulfill the strict linearity requirements imposed by the standard. Because of this, the digital predistortion (DPD) of RF-PAs has become a key technique for implementing energy efficient, high data rate wireless transmitters. This thesis investigates theoretical foundations and practical methods for the behavioral modeling and DPD of RF-PAs. The main contributions are a semi-physical model of the joint linearity-efficiency characteristics of RF-PAs, a detailed analysis of polynomial baseband models of RF-PAs focusing on the often neglected even-order terms in baseband, and a collection of practical methods for ...

Compensating or reducing the nonlinear distortion - usually resulting from a nonlinear system - is becoming an essential requirement in many areas. In this thesis adaptive digital predistortion techniques for a wide class of nonlinear systems are presented. For estimating the coefficients of the predistorter, different learning architectures are considered: the Direct Learning Architecture (DLA) and Indirect Learning Architecture (ILA). In the DLA approach, we propose a new adaptation algorithm - the Nonlinear Filtered-x Prediction Error Method (NFxPEM) algorithm, which has much faster convergence and much better performance compared to the conventional Nonlinear Filtered-x Least Mean Squares (NFxLMS) algorithm. All of these time domain adaptive algorithms require accurate system identification of the nonlinear system. In order to relax or avoid this strict requirement, the NFxLMS with Initial Subsystem Estimates (NFxLMS-ISE) and NFxPEM-ISE algorithms are proposed. Furthermore, we propose a frequency ...

Nowadays, many disciplines in science and engineering deal with problems for which a solution relies on knowledge about the characteristics of one or more given systems that can only be ascertained based on restricted observations. This requires the fitting of an adequately chosen model, such that it “best” conforms to a set of measured data. Depending on the context, this fitting procedure may resort to a huge amount of recorded data and abundant numerical power, or contrarily, to only a few streams of samples, which have to be processed on the fly at low computational cost. This thesis, exclusively focuses on the latter scenario. It specifically studies unexpected behaviour and reliability of the widely spread and computationally highly efficient class of gradient type algorithms. Additionally, special attention is paid to systems that combine several of them. Chapter 3 is dedicated ...

The aim of this dissertation is the investigation of the key issues encountered in the development of wideband radio air-interfaces. Orthogonal frequency-division multiplexing (OFDM) is considered as the enabling technology for transmitting data at extremely high rates over time-dispersive radio channels. OFDM is a transmission scheme, which splits up the data stream, sending the data symbols simultaneously at a drastically reduced symbol rate over a set of parallel sub-carriers. The first part of this thesis deals with the modeling of the time-dispersive and frequency-selective radio channel, utilizing second order Gaussian stochastic processes. A novel channel measurement technique is developed, in which the RMS delay spread of the channel is estimated from the level-crossing rate of the frequency-selective channel transfer function. This method enables the empirical channel characterization utilizing simplified non-coherent measurements of the received power versus frequency. Air-interface and multiple ...

To satisfy the continuously growing demands for higher data rates, modern radio communication systems employ larger bandwidths and more complex waveforms. Furthermore, radio devices are expected to support a rich mixture of standards such as cellular networks, wireless local-area networks, wireless personal area networks, positioning and navigation systems, etc. In general, a "smart'' device should be flexible to support all these requirements while being portable, cheap, and energy efficient. These seemingly conflicting expectations impose stringent radio frequency (RF) design challenges which, in turn, call for their proper understanding as well as developing cost-effective solutions to address them. The direct-conversion transceiver architecture is an appealing analog front-end for flexible and multi-standard radio systems. However, it is sensitive to various circuit impairments, and modern communication systems based on multi-carrier waveforms such as Orthogonal Frequency Division Multiplexing (OFDM) and Orthogonal Frequency Division Multiple ...

In this thesis novel implementation approaches for standardized and non-standardized ultra wide-band (UWB) systems are presented. These implementation approaches include signal processing algorithms to achieve processing of UWB signals in transceiver front-ends and in digital back-ends. A parallelization of the transceiver in the frequency-domain has been achieved with hybrid filterbank transceivers. The standardized MB-OFDM signaling scheme allows par- allelization in the frequency domain by distributing the orthogonal multicarrier modulation onto multiple units. Furthermore, the channel’s response to wideband signals has been parallelized in the frequency domain and the effects of the parallelization have been investi- gated. Slight performance decreases are observed, where the limiting effects are truncated sidelobes and filter mismatches in analog front-ends. Measures for the performance loss have been defined. For UWB signal generation, a novel broadband signal generation approach is presented. For that purpose, multiple digital-to-analog converters ...

This thesis focuses on different nonlinear distortion aspects in radio transmitter and receivers. Such nonlinear distortion aspects are generally becoming more and more important as the communication waveforms themselves get more complex and thus more sensitive to any distortion. Also balancing between the implementation costs, size, power consumption and radio performance, especially in multiradio devices, creates tendency towards using lower cost, and thus lower quality, radio electronics. Furthermore, increasing requirements on radio flexibility, especially on receiver side, reduces receiver radio frequency (RF) selectivity and thus increases the dynamic range and linearity requirements. Thus overall, proper understanding of nonlinear distortion in radio devices is essential, and also opens the door for clever use of digital signal processing (DSP) in mitigating and suppressing such distortion effects. On the receiver side, the emphasis in this thesis is mainly on the analysis and DSP ...

Digital subscriber line (DSL) technology is one of the fastest growing broadband internet access media. Whereas asymmetric DSL (ADSL) already offers data rates of a few megabits per second, next-generation ADSL2+ and VDSL promise even higher bit rates to support so-called triple play (high-quality video, voice and high-speed data). The use of a large bandwidth over the phone line (up to 12 MHz for VDSL) induces impairments, such as severe channel distortion, echo, narrow-band radiofrequency interference (RFI) and crosstalk from other DSL systems. DSL communication makes use of so-called discrete multitone (DMT) modulation, supplemented with advanced digital signal processing algorithms, to tackle these impairments and serve a maximum number of customers. In this thesis, we focus on channel equalization and RFI mitigation algorithms that outperform existing algorithms in terms of bit rate. DMT equalization is typically done by means of ...

Massive MIMO (multiple-input–multiple-output) is a multi-antenna technology for cellular wireless communication, where the base station uses a large number of individually controllable antennas to multiplex users spatially. This technology can provide a high spectral efficiency. One of its main challenges is the immense hardware complexity and cost of all the radio chains in the base station. To make massive MIMO commercially viable, inexpensive, low-complexity hardware with low linearity has to be used, which inherently leads to more signal distortion. This thesis investigates how the degenerated linearity of some of the main components—power amplifiers, analog-to-digital converters (ADCs) and low-noise amplifiers—affects the performance of the system, with respect to data rate, power consumption and out-of-band radiation. The main results are: Spatial processing can reduce PAR (peak-to-average ratio) of the transmit signals in the downlink to as low as 0B; this, however, does ...

Modern signal processing applications emerging in telecommunication and instrumentation industries need high-speed analog-to-digital converters (ADCs), which can be achieved by employing a time-interleaved parallel array of ADCs (time-interleaved ADCs). The time interleaving of the channels allows to increase the sampling rate by the number of channels compared to a single channel. Unfortunately, time-interleaved ADCs suffer from channel mismatches that limit their performance, wherefore this thesis deals with the identification and compensation of channel mismatches in time-interleaved ADCs. By using nonlinear hybrid filter banks, we have modeled and analyzed channel mismatches in detail. The model covers linear and nonlinear channel mismatches, unifies, and extends the channel models found in the literature. A novel foreground channel mismatch identification method has been developed, which can be used to fully characterize dynamic linear mismatches. A background identification method provides accurate timing mismatch estimates. Finally, ...

Room acoustic signal enhancement (RASE) applications, such as digital equalization, acoustic echo and feedback cancellation, which are commonly found in communication devices and audio equipment, aim at processing the acoustic signals with the final goal of improving the perceived sound quality in rooms. In order to do so, signal processing algorithms require the acoustic response of the room to be represented by means of parametric models and to be identified from the input and output signals of the room acoustic system. In particular, a good model should be both accurate, thus capturing those features of room acoustics that are physically and perceptually most relevant, and efficient, so that it can be implemented as a digital filter and used in practical signal processing tasks. This thesis addresses the fundamental question in room acoustic signal processing concerning the appropriateness of different parametric ...

The error vector magnitude (EVM) is a standard metric to quantify the performance of digital communication systems and related building blocks. Regular EVM measurements require expensive equipment featuring inphase and quadrature (IQ) demodulation, wideband analog-to-digital converters (ADCs), and dedicated receiver algorithms to demodulate the data symbols. With modern high data rate communication standards that require high bandwidths and low amounts of error, it is difficult to avoid bias due to errors in the measurement chain. This thesis develops and discusses measurement methods that address the above-described issues with EVM measurements. The first method is an extension of the regular EVM, yielding two results from a single measurement. One result equals the regular EVM result, whereas the other excludes potential errors due to mismatches of the I- and Q- paths of direct conversion transmitters and receivers (IQ imbalance). This can be ...

OFDM is a multicarrier modulation system widely used in wireline and wireless applications such as DVB-T/T2, Wifi, and LTE, due to its resilience against frequency selective channels compared with the single carrier modulation systems. However, the OFDM signal suffers from large amplitude variations. The fluctuations of the OFDM envelope generate non-linear distortions when we introduce the signal into a non-linear device like the power amplifier. Reducing the variations of the signal improves the power amplifier efficiency, reduces the energy consumption and decreases CO2 emissions. The peak-to-average power ratio (PAPR) has been introduced as a random variable that measures the power variations of the signal. There exist several multicarrier modulation systems based on different modulation basis and shaping filters. We first prove in this work that the PAPR depends on this modulation structure. Moreover, the behaviour of the PAPR regarding the ...

Sigma delta modulation has become a widespread method of analogue to digital conversion, however its operation has not been completely defined. The majority of the analysis carried out on the circuit has been from a linear standpoint, with non-linear analysis hinting at hidden complexities in the modulator’s operation. The sigma delta modulator itself is a non-linear system consisting, as it does, of a number of integrators and a one bit quantiser in a feedback loop. This configuration can be generalised as a non-linearity within a feedback path, which is a classic route to chaotic behaviour. This initially raises the prospect that a sigma delta modulator may be capable of chaotic modes of operation with a non-chaotic input. In fact, the problem does not arise and we show why not. To facilitate this investigation, a set of differential equations is formulated ...