Since Marconi succeeded in carrying out the first wireless transmission in 1894, experimental research has been always linked with wireless communications. Today, most wireless communications research relies only on computer simulations. Although computer simulations are necessary and recommendable for wireless systems evaluation, they only reflect the simulation environment rather than the actual scenarios in which wireless systems operate. Consequently, it is desirable to assess wireless communications systems in real-world scenarios while, at the same time, keeping the required effort within reasonable terms. Among the different strategies suitable for undertaking such assessment, the testbed approach constitutes a simple and flexible enough solution based on the software-defined radio concept in which only the fundamental operations (usually the transmission and the acquisition) are carried out in real- time, while the remaining tasks are implemented off-line in high-level programming languages (e.g. MATLAB) and using ...

In this work, a realistic physical layer performance evaluation of High Speed Downlink Packet Access (HSDPA) as well as IEEE 802.16-2004, commonly referred to as Worldwide Inter-operability for Microwave Access (WiMAX), is provided. The performance evaluation is carried out in two measurement campaigns that took place in an alpine and an urban environment. Both, WiMAX and HSDPA use adaptive modulation and coding to adapt the channel coding rate and the size of the symbol alphabet to the current channel conditions. Additionally, both systems allow for multiple transmit and multiple receive antennas to increase the spectral efficiency and the reliability of the transmission. While WiMAX utilizes multiple transmit antennas by simple Alamouti space-time coding, HSDPA implements a closed-loop system with channel adaptive spatial precoding. The necessary, quantized channel information is fed back from the user equipment to the base station. The ...

The goal of this Ph.D. dissertation is to address a number of challenges encountered in the digital baseband design of modern and future wireless communication systems. The fast and continuous evolution of wireless communications has been driven by the ambitious goal of providing ubiquitous services that could guarantee high throughput, reliability of the communication link and satisfy the increasing demand for efficient re-utilization of the heavily populated wireless spectrum. To cope with these ever-growing performance requirements, researchers around the world have introduced sophisticated broadband physical (PHY)-layer communication schemes able to accommodate higher bandwidth, which indicatively include multiple antennas at the transmitter and receiver and are capable of delivering improved spectral efficiency by applying interference management policies. The merging of Multiple Input Multiple Output (MIMO) schemes with the Orthogonal Frequency Division Multiplexing (OFDM) offers a flexible signal processing substrate to implement ...

When data is transmitted over the wireless communication channel, the transmit signal experiences distortion depending on the channel¢s fading characteristics. On the one hand, this calls for efficient processing at the receiver to mitigate the detrimental effects of the channel and maximize data throughput. On the other hand, the diversity inherently present in these channels can be leveraged with appropriate transmit processing in order to increase the reliability of the transmission link. Recently, in [1] it was shown that the channel characteristics can be exploited to maximize the total data throughput in the interference channel where multiple user pairs rely on the same resource to communicate among themselves. In this PhD dissertation, we first propose novel equalizer designs for frequency selective channels. We then present new results on the diversity gain of equalizers in fading channels when appropriate precoding is ...

This thesis is concerned with the use of multiple antenna elements in wireless communication over frequency non-selective radio channels. Both measurement results and theoretical analysis are presented. New transmit strategies are derived and compared to existing transmit strategies, such as beamforming and space time block coding (STBC). It is found that the best transmission algorithm is largely dependent on the channel characteristics, such as the number of transmit and receive antennas and the existence of a line of sight component. Rayleigh fading multiple input multiple output (MIMO) channels are studied using an eigenvalue analysis and exact expressions for the bit error rates and outage capacities for beamforming and STBC is found. In general are MIMO fading channels correlated and there exists a mutual coupling between antenna elements. These findings are supported by indoor MIMO measurements. It is found that the ...

The use of multiple antennas at base stations and user devices is a key component in the design of cellular communication systems that can meet the capacity demands of tomorrow. The downlink transmission from base stations to users is particularly limiting, both from a theoretical and a practical perspective, since user devices should be simple and power-efficient, and because many applications primarily create downlink traffic (e.g., video streaming). The potential gain of employing multiple antennas for downlink transmission is well recognized: the total data throughput increases linearly with the number of transmit antennas if the spatial dimension is exploited for simultaneous transmission to multiple users. In the design of practical cellular systems, the actual benefit of multiuser multiantenna transmission is limited by a variety of factors, including acquisition and accuracy of channel information, transmit power, channel conditions, cell density, user ...

Interaction between the Medium Access Control (MAC)-layer and the physical-layer routines is one of the basic concepts of modern wireless networks. Physical-layer dependent resource allocation and scheduling guarantee efficient network utilization. Accordingly, classical link-level analyses, focusing only on the physical-layer are not sufficient anymore for optimum transceiver structure and algorithm development. This thesis presents the development and application of a system-level description suitable for the downlink of Multiple-Input Multiple-Output (MIMO) enhanced High-Speed Downlink Packet Access (HSDPA), with particular focus on the Double Transmit Antenna Array (D-TxAA) transmission mode. The system-level model allows for investigating and evaluating transmission systems and algorithms in the context of cellular networks. Two separate models are proposed to obtain a complete system-level description: (i) a link-quality model, analytically describing the MIMO HSDPA link quality in a so-called equivalent fading parameter structure, and (ii) a link-performance model, ...

The emergence of very capable mobile terminals, e.g. smartphones or tablets, has dramatically increased the demand of wireless data traffic in recent years. Current growth forecasts elucidate that wireless communication standards will not be able to afford future traffic demands, thus many research efforts have been oriented towards increasing the efficiency of wireless networks. Wireless communications introduce many issues not present in wired systems, e.g. multipath effects or interference. Some of these issues may be tackled by the use of multiple antennas, i.e. MIMO technologies. This solution allows increasing not only the reliability and robustness of the communications, i.e. the diversity gain, but also its efficiency, i.e. the multiplexing gain or degrees of freedom (DoF). The DoF describe the slope of channel capacity at very high signal-to-noise-ratio (SNR) regime. For a point-to-point (P2P) communication, assuming that the wireless channel response ...

Developing realistic channel models is one of the greatest challenges for describing wireless communications. Their quality is crucial for accurately predicting the performance of a wireless system. While on the one hand, channel models have to be accurate in describing the physical properties of wave propagation, on the other hand, they have to be as least complex as possible. With the recent emergence of antennas with a massive amount of elements as a promising technology for a further enhancement of spectral efficiency, new channel models that characterize the propagation environment in both azimuth and elevation become necessary. While standardization bodies such as 3rd Generation Partnership Project (3GPP) and International Telecommunications Unit (ITU) have introduced a 3-dimensional (3D) geometry-based stochastic channel model, a system-level modeling has been missing to serve the purpose of further analysis and evaluations. Furthermore, with such a ...

Massive multiple-input multiple-output (MIMO) evolved to a key enabling physical layer (PHY) technology for the fifth generation (5G) of mobile communication systems and beyond. While the envisioned use cases of such communications systems are diverse, so are the challenges to meet their respective requirements. As a large-scale evolution of already well-established MIMO communications technologies, massive MIMO promises benefits with respect to all possible use cases. Theoretical works on massive MIMO, however, typically assumes i.i.d. Rayleigh fading channels without spatial channel correlation. The application of this model is justified through the assumption of rich scattering environments, which is claimed to hold, for example, in indoor environments. Spatial correlation of wireless channels leads to inter-stream interference in single-user MIMO communications systems and to inter-user interference in multi-user MIMO systems with linear precoding. Channel correlation is therefore crucial for the performance of such ...

The thriving development of wireless communications calls for innovative and advanced signal processing techniques targeting at an enhanced performance in terms of reliability, throughput, robustness, efficiency, flexibility, etc.. This thesis addresses such a compelling demand and presents new and intriguing progress towards fulfilling it. We mainly concentrate on two advanced multi-dimensional signal processing challenges for wireless systems that have attracted tremendous research attention in recent years, multi-carrier Multiple-Input Multiple-Output (MIMO) systems and multi-dimensional harmonic retrieval. As the key technologies of wireless communications, the numerous benefits of MIMO and multi-carrier modulation, e.g., boosting the data rate and improving the link reliability, have long been identified and have ignited great research interest. In particular, the Orthogonal Frequency Division Multiplexing (OFDM)-based multi-user MIMO downlink with Space-Division Multiple Access (SDMA) combines the twofold advantages of MIMO and multi-carrier modulation. It is the essential element ...

Multiple input multiple output (MIMO) techniques have been widely employed by dif- ferent wireless systems with many advantages. By using multiple antennas, the system is able to transmit multiple data streams simultaneously and within the same frequency band. The methods known as spatial multiplexing (SM) and spatial diversity (SD) im- proves the high spectral efficiency and link reliability of wireless communication systems without requiring additional transmitting power. By introducing channel coding in the transmission procedure, the information redundancy is introduced to further improve the reliability of SM links and the quality of service for the next generation communication systems. However, the throughput performance of these systems is limited by interference. A number of different interference suppression techniques have been reported in the literature. Theses techniques can be generally categorised into two aspects: the preprocessing techniques at the transmitter side and ...

In this thesis I describe the setup and design of a flexible rapid prototyping platform for RFID systems to provide an experimental verification environment for RFID systems, that allows their real-time exploration in distinct measurement setups. Furthermore, I use this system to test the feasibility of novel signal processing algorithms for RFID reader receivers, which promise a performance increase to state-of-the-art-receivers. Three different scenarios are considered: 1. In the first scenario, a single tag communicates with a single receive antenna reader. The performance of the optimal maximum likelihood sequence decoder is identified, and losses due to channel estimation and synchronisation are discussed. Due to the wide deviation from the nominal data rate in the uplink communication, especially synchronisation shows to be a critical issue. 2. In the second scenario, the single tag communicates with a multiple receive antenna RFID reader. ...

The aim of this dissertation is the investigation of the key issues encountered in the development of wideband radio air-interfaces. Orthogonal frequency-division multiplexing (OFDM) is considered as the enabling technology for transmitting data at extremely high rates over time-dispersive radio channels. OFDM is a transmission scheme, which splits up the data stream, sending the data symbols simultaneously at a drastically reduced symbol rate over a set of parallel sub-carriers. The first part of this thesis deals with the modeling of the time-dispersive and frequency-selective radio channel, utilizing second order Gaussian stochastic processes. A novel channel measurement technique is developed, in which the RMS delay spread of the channel is estimated from the level-crossing rate of the frequency-selective channel transfer function. This method enables the empirical channel characterization utilizing simplified non-coherent measurements of the received power versus frequency. Air-interface and multiple ...

Massive multiple input multiple output (MIMO) is a promising 5G and beyond-5G wireless access technology that can provide huge throughput, compared with the current technology, in order to satisfy some requirements for the future generations of wireless networks. The research described in this thesis proposes the design of some applications of the massive MIMO technology that can be implemented in order to increase the spectral efficiency per cell of the future wireless networks through a simple and low complexity signal processing. In particular, massive MIMO is studied in conjunction with two other topics that are currently under investigation for the future wireless systems, both in academia and in industry: the millimeter wave frequencies and the distributed antenna systems. The first part of the thesis gives a brief overview on the requirements of the future wireless networks and it explains some ...